BS EN 934-4:2009 pdf free download – Admixtures for concrete, mortar and grout – Part 4: Admixtures for grout for prestressing tendons – Definitions, requirements, conformity, marking and labelling.
ZA.1 Clauses of this European Standard addressing the provisions of the EU Construction Products Directive
This European Standard has been prepared under Mandate M/128 “Products related to concrete, mortar and grout” given to CEN by the European Commission and European Free Trade Association.
The clauses of this European Standard, shown in this Annex below, meet the requirements of the mandate given under EU Construction Products Directive (89/106/EEC).
Compliance with these clauses confers a presumption of fitness of the admixtures for concrete covered by this annex for their intended uses indicated herein; reference shall be made to the information accompanying the CE marking.
WARNING Other requirements and other EU Directives, not affecting the fitness for intended use(s), may be applicable to the construction products falling within the scope of this standard.
NOTE 1 In addition to any specific clauses relating to dangerous substances contained in this standard, there may be other requirements applicable to the products falling within its scope (e.g. transposed European legislation and national laws, regulations and administrative provisions). In order to meet the provisions of the EU Construction Products Directive, these requirements need also to be complied with, when and where they apply.
NOTE 2 An informative database of European and national provisions on dangerous substances is available at the Construction web site on EUROPA (accessed through
http://ec.europa .eu/enterprise/construction/internal/dangsu b/danqmain en.htm).
This annex establishes the conditions for the CE marking of the admixtures for concrete intended for the uses indicated in Table ZA.1 and shows the relevant clauses applicable.
This annex has the same scope as Clause 1 of this standard and is defined by Table ZA.1
ZA.2.2 EC certification and declaration of conformity
When compliance with the conditions of this annex is achieved, and once the notified body has drawn up the certificate mentioned below, the manufacturer or his agent established in the EEA shall draw up and retain a declaration of conformity, which entitles the manufacturer to affix the CE marking. This declaration shall include:
— name and address of the manufacturer, or his authorised representative established in the EEA, and place of production,
NOTE 1 The manufacturer may also be the person responsible for placing the product onto the EEA market, if he takes responsibility for CE marking.
— description of the product (type, identification, use,…), and a copy of the information accompanying the CE marking
NOTE 2 Where some of the information required for the Declaration is already given in the CE marking information, it does not need to be repeated.
— provisions to which the product conforms (i.e. annex ZA of this EN), and a reference to the ITT report(s) and factory production control records (if appropriate),
particular conditions applicable to the use of the product (e. g. provisions for the use under certain conditions),
— the number of the accompanying factory production control certificate, and FPC records, where applicable,
— name and address of the notified laboratory(ies) if some characteristics are tested by such a laboratory, name of, and position held by, the person empowered to sign the declaration on behalf of the manufacturer or his authorised representative.
The declaration shall be accompanied by a factory production control certificate, drawn up by the notified body, which shall contain, in addition to the information above, the following:
— name and address of the notified body,
— the number of the factory production control certificate,
— conditions of validity of the certificate, where applicable,
— name of, and position held by, the person empowered to sign the certificate.