IEC 60809:2021 pdf free download – Lamps and light sources for road vehicles – Dimensional, electrical andluminous requirements
The requirements for miniature light sources for supplementary purposes,not subject tolegislation,are specified in lEC 60983.
NOTE 1 The terms “lamp” and “light source” are both used in this document to mean the same product, so the twoterms are interchangeable throughout this document.
NOTE 2 In various vocabularies and standards，different terms are used for “incandescent lamp”(IEC 60050-845:1987，845-07-04),”discharge lamp”(IEC 60050-845:1987,845-07-17) and “LED lamp”. In thisdocument “filament lamp” , “discharge lamp” and “LED light source” are used, however, where only “lamp” or “lightsource” is written, all light sources, independent of the technology used, are meant, unless the context clearly showsthat it applies to one kind of technology only. In the UN Regulations, the word “light source” is used for the productsspecified in this document.
NOTE 3 Wherever the term “device” is used, it is meant to designate equipment which is used as a luminaire. ltcan for instance take the form and purpose of a headlight or signal light.
2Normative references
The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document. For dated references, only the edition cited applies.For undated references,the latest edition of the referenced document (including anyamendments) applies.
IEC 60050-845,International Electrotechnical Vocabulary – Part 845: Lighting (available athttp://www.electropedia.org/)
IEC 60051-1，Direct acting indicating analogue electrical measuring instruments and theiraccessories – Part 1: Definitions and general requirements common to all parts
IEC 60061-1,Lamp caps and holders together with gauges for the control of interchangeabilityand safety – Part 1:Lamp caps (available at http:/lstd.iec.ch/iec60061)
United Nations,Vehicle Regulations – 1958 Agreement,Agreement concerning the Adoption ofHarmonized Technical United Nations Regulations for Wheeled Vehicles,Equipment and Partswhich can be Fitted and/or be Used on Wheeled Vehicles and the Conditions for ReciprocalRecognition of Approvals Granted on the Basis of these United Nations Regulations(Revision 3)1
Available at: www.unece.org/trans/main/wp29/wp29regs.html (website checked 2021-01-18)
Addendum 3: Regulation No.4， Uniform provisions concerning the approval of devices forthe illumination of rear registration plates of power-driven vehicles and their trailers
Addendum 5: Regulation No. 6，Uniform provisions concerning the approval of directionindicators for power-driven vehicles and their trailers
Addendum 6: Regulation No. 7,Uniform provisions concerning the approval of front andrear position lamps, stop-lamps and end-outline marker lamps for motor vehicles and theirtrailers
Addendum 22:Regulation No.23, Uniform provisions concerning the approval of reversingand manoeuvring lamps for power-driven vehicles and their trailers
Addendum 36: Regulation No.37,Uniform provisions concerning the approval of filamentlamps for use in approved lamp units of power-driven vehicles and of their trailers
Addendum 37: Regulation No.38,Uniform provisions concerning the approval of rear foglamps for power-driven vehicles and their trailers
Addendum 47: Regulation No.48,Uniform provisions concerning the approval of vehicleswith regard to the installation of lighting and light-signalling devices
Addendum 49: Regulation No. 50，Uniform provisions concerning the approval of frontposition lamps,rear position lamps,stop lamps, direction indicators and rear-registration-plate illuminating devices for vehicles of category L
Addendum 76: Regulation No.77,Uniform provisions concerning the approval of parkinglamps for power-driven vehicles
Addendum 86: Regulation No.87，Uniform provisions concerning the approval of daytimerunning lamps for power-driven vehicles
Addendum 90: Regulation No.91，Uniform provisions concerning the approval of side-marker lamps for motor vehicles and their trailers
Addendum 98: Regulation No. 99，Uniform provisions concerning the approval of gas-discharge light sources for use in approved gas-discharge lamp units of power-drivenvehicles
Addendum 100: Regulation No. 101，Uniform provisions concerning the approval ofpassenger cars powered by an internal combustion engine only, or powered by a hybridelectric power train with regard to the measurement of the emission of carbon dioxide andfuel consumption and/or the measurement of electric energy consumption and electric range,and of categories Mand N, vehicles powered by an electric power train only with regard tothe measurement of electric energy consumption and electric range